If you run more than three bridges, run an even distribution of bridges with iat_mode set to 0, 1 and 2, if you run only three bridges, one with each setting, if two, then 0 and 2, if only one, run it with 2 due to the lack of bridges supporting it, et cetera.
That's how I would handle it..
- William
2021-02-24 23:44 GMT, Eddie stunnel@attglobal.net:
On 2/24/2021 12:34 PM, William Kane wrote:
Thank you for running obfs4 bridges with iat_mode != 0, only very few obfs4 bridges support the additional traffic obfuscation in both directions.
Kudos to you my friend.
- William
Should I take this as a recommendation to update my bridges to support iat_mode=2.
Cheers.
2021-02-23 1:18 GMT, torjoy south_america_bridges@protonmail.com:
Hi All,
I work with time and frequency references and run some tor bridges. What is the objective of "iat_mode" setting? Is an good timming reference important for this setting? For now, i'm adminstrating 3 briges, one with iat_mode=0, iat_mode=1 and iat_mode=2. Could you explain or forward me to some reading about it?
Best regards,
Luiz
Sent with [ProtonMail](https://protonmail.com) Secure Email.
tor-relays mailing list tor-relays@lists.torproject.org https://lists.torproject.org/cgi-bin/mailman/listinfo/tor-relays
This e-mail was checked for spam by the freeware edition of CleanMail. The freeware edition is restricted to personal and non-commercial use. You can remove this notice by purchasing a commercial license: http://antispam.byteplant.com/products/cleanmail/index.html
tor-relays mailing list tor-relays@lists.torproject.org https://lists.torproject.org/cgi-bin/mailman/listinfo/tor-relays