I delayed moving from 0.2.3.7-alpha to 0.2.3.10-alpha until now because the latter failed to build from source under FreeBSD 7.4-STABLE. Oddly enough, now that I've upgraded to 8.2-STABLE, it appears to build just fine. So I ran a tor --verify-config on my existing torrc file, which was confirmed to be okay by 0.2.3.10-alpha. Next, I fired it up, and...no log files were created, :-( so I had no idea whether it was working, had encountered any difficulties during initialization, etc. It should have created two log files in /var/log/tor/, one for "notice" and above, and one for "info" and above. I tried a SIGHUP to get it to reread torrc, which made no observable change, as expected. After pondering the situation for a few minutes, I decided to shut it down. If tor can't communicate to its operator, then it can't be safely run. If anyone can feed me a clue about what to try in hopes of fixing this, I'd greatly appreciate it. If there are no helpful ideas forthcoming by this evening, I'll likely go back to 0.2.3.7-alpha in order to have a working node. Thanks much. Scott Bennett, Comm. ASMELG, CFIAG ********************************************************************** * Internet: bennett at cs.niu.edu * *--------------------------------------------------------------------* * "A well regulated and disciplined militia, is at all times a good * * objection to the introduction of that bane of all free governments * * -- a standing army." * * -- Gov. John Hancock, New York Journal, 28 January 1790 * **********************************************************************