Hi, Just setting up a new bridge, on a new VPS, to complement the relay I run at home and have a couple of questions regarding best practices. I set the bridge up from scratch, so it has no connections back to my relay fingerprint etc. as I understand that's "a bad thing". I've seen a few comments mentioning the lack of obfs4 bridges using port 443, so as I don't run any kind of webserver on the VPS I can do this. I also wanted to run an obfuscated bridge on port 80, but it seems that you can only run a single instance of obfs4. Searching around, the most common setup I found was this: ServerTransportListenAddr obfs3 [::]:80 ServerTransportListenAddr obfs4 [::]:443 Is this the best way to support both port 80 and 443, or is there a better way. Next, the ORPort. There seems to be confusing information about setting this up, in conjunction with obfs4proxy. Again, my setup: ORPort 9001 ORPort [--my public ipv6 address--]:9002 Again, is the the best way, as I've seen some information that says avoid 9001, but others say it's OK to use for a bridge, with obfs4proxy. Cheers.