Thanks Roger, Sebastian, and Jens! Your advice worked perfectly, and I didn't have to take any downtime.
On Sun, Feb 8, 2015 at 8:13 PM, Roger Dingledine arma@mit.edu wrote:
On Mon, Feb 09, 2015 at 04:29:01AM +0100, Sebastian Urbach wrote:
I'd like to reload torrc; I think I can do this by either restarting
tor or
by sending a SIGHUP to the tor process, but I'm not sure how much of a service interruption each of these approaches will cause.
What's the best way to reload torrc (i.e. how can I do this in a way
that
minimizes the service interruption)?
If it is just reloading the torrc and nothing else then SIGHUP ie the best way to do that.
If you're using the deb, "service tor reload" is slightly better -- this init script will run Tor on your torrc with --verify-config first, in case it notices anything that is going to make your Tor exit when it parses the new torrc.
If the Tor run with --verify-config complains, then the init script will opt not to send the hup signal, and instead give you a warning.
The goal is to reduce the number of situations where you hup your Tor and then it quietly writes out a complaint about the new torrc file and exits, but you don't notice that it's gone.
--Roger
tor-relays mailing list tor-relays@lists.torproject.org https://lists.torproject.org/cgi-bin/mailman/listinfo/tor-relays